SK Creations  ·  3D Print

U fly
Quiet
Adapter

Silence the rotor. A 3D-printable vibration dampening adapter that decouples motor noise from your frame — without adding weight or compromising thrust.

0 g Weight penalty
Free Print it yourself
STL Open format
Download STL Print Guide
Interactive 3D model Drop an .stl file here to preview

Drag to rotate  ·  Scroll to zoom  ·  Right-drag to pan

Why it works

Engineered for
quiet flight.

Vibration Decoupled

The snap-fit geometry isolates motor resonance from the airframe. High-frequency harmonics are absorbed at the adapter — not transmitted into the body where they amplify.

Print Ready

No supports required. Flat bed orientation. Optimised topology for FDM. Slice it, set it, and your printer does the rest in under 2 hours on a standard 0.4mm nozzle.

Zero Compromise

Full thrust efficiency maintained. No aerodynamic penalty. The adapter sits below the prop plane — out of airflow — so your flight performance stays exactly as tuned.

Before you print

Print specifications.

Recommended materialPETG
Alternate materialPLA+
Layer height0.2 mm
Infill40%
Perimeter walls3
SupportsNone
Print time~1.5 hrs
Nozzle temp (PETG)240 °C
Bed temp (PETG)60 °C

Use PETG, not PLA. The slight flex in PETG gives better vibration absorption than rigid PLA. TPU is too soft — it deflects under prop wash and causes runout. ABS warps without an enclosure and compromises the fit geometry.

  1. Download and open in your slicer Import the STL into Cura, Bambu Studio, or PrusaSlicer. The model is pre-oriented — no rotation needed.
  2. Apply the specs from the table Set layer height to 0.2mm, 40% infill, 3 perimeter walls, no supports. Slow the first layer to 30 mm/s for adhesion on the circular base.
  3. Print and let it cool completely PETG continues to firm up as it cools. Remove from bed only after it reaches room temperature — pulling it early can deform the tight-tolerance fit ring.
  4. Test fit before flight Snap onto the motor post. It should be firm but removable by hand. Too tight? Add +0.1 mm horizontal expansion in your slicer. Too loose? Drop it by 0.1 mm.

Ready to
print it?

Free to download. Free to print. Share freely.

Download STL File ↓